Hi my secondary cat has gone bad so I’m fitting a corksport racepipe, I currently have a corksport Sri, am I okay to use the tune for cpe cai and corksport racepipe?

Thanks for looking, I am not running the crackle and pop map just the normal high load, I have changed the lowest idle rpms to 800 to reduce flywheel chatter, I don’t know if this would affect the reading? Good to know it’s nothing serious though, I’ll try nvestigate an exhaust leak that would make ...

hi theses are the logs. if you could take a look id appreciate. thanks.

Thanks for the reply, I’ll get some plugs plugs ordered, I found NGK 95605/LTRBHX they sell them gapped to 0.711mm for a me 3 focus st would this be okay?
I’ll get some logs tonight and check back in.

Hi it’s time again to change my spark plugs so I’m looking for spark plug and gap recommendations for a gen 2. I’m currently running the high load tune and the only current mods are hpfp internals, corksport stage 2 short ram intake and gfb recirc valve. Also I don’t have much knowledge but the car ...

hi i'm at a dead end with the obdlink sx, the car is getting an e tune soon and i cannot get it to work, it has worked in the past once or twice but now i cant get it to connect at all. the light is green when plugged into the car and odlink sx comes up in the list of devices but versatuner says it ...

Okay great thanks, so would I be safe to basically change all the 700 rpm values to 800? I only have a rear motor mount so it should be fine I think.

Hi I need help adjusting warm idle speed, after fitting a lightweight flywheel I’d like to increase the idle to around 850 rpm to help reduce chatter, After trying to edit my current map I’m confused which section on the idle needs to be changed, there are a lot of subsections, can I just adjust the...

I'm having alot of trouble connecting the obdlink sx to the car. All the drivers are updated and installed, I've done this quite a few times with no luck. I've tried using obdwiz and I'm also not connecting on there. Error says "connected to scan tool but not vehicle" I've managed to conne...

That's great thanks for the quick reply.