Thanks mutic... for some reason i did not see that i put in MAP voltage instead of maf voltage... dam that was thick of me. Had a look and sorted that out... will post some logs once i get some kms back up and running... Why though does the car show stft's even in open loop... should it not show 0 o...

good day everyone. seasons greetings to u all. have not been here in a while. I am currently having trouble figuring out why my maf voltages and maf read out do not correlate. not sure if it is a sensor problem that is causing it. below I have attached my logs I did today versus my logs I did in aug...

hi guys i have not been on the forum in a while. i am currently busy with a big turbo build. car is finally up and running. now comes the tuning. looking at using a 3.5 inch maf housing, to get in as much air as possible. does anyone have a maf cali scale for it, also if anyone could assist in maps ...

how would u know if the timing had made a difference other than a dyno, i.e: engine load or maf? taking my car on Tuesday for its first dyno, quite excited. but without any timing added. then after this week, will install the 3.5 bar bosch map sensor, then slowly add timing, but is there a max timin...

thanks dave for your reply. ok will do that to open and closed loop tables, but does the car not wanna adv timing till it reaches max, and if max is set below open and closed loop will that be the limiting factor? at the moment from 4500 till 6500 rpm i have 0 knock, due to the meth working so well....

how would u know if u are making more power, ie: flowing more grams per second or the load tapering is at a higher value ie, instead of lowering to 1.75 now drops to 1.85, as an example? also my 3.5 bar bosch sensor just arrived, what are the scalers and offset values. mathematically i worked out A-...

hi guys got the boost issue on the hybrid turbo finally sorted. the issue i found was the stock ebcs, and finding an adequate restrictor pill. switched over to a 3port and worked great. flowing around 285-290 g/s at 1.4 bar/2.2 load. the gt 28 works so well in holding boost compared to the k04. :bou...

i think i may have found the problem, but wanna run somemore tests, hopefully this weekend. (2 clamps on my fmic setup are damaged, waiting to get new ones).

hi there pls need some help, i have fitted a gt 28 hybrid same turbo that ricardo yen has. the issue i am having is the car will not hold boost through out the rpm range, nor reach my load target of 2.1. the car will boost to 1.35 as requested reach the load target of 2.1 and then continue to drop. ...

hi guys would anyone know if versatune will work on windows 7 starter and also minimum pc requirements