Flat foot shifting on an ND2 how does it work? Is the rpm and shift cut configurable? I want to one day wire the clutch switch to a shift knob switch on a sequential transmission for clutchless shifting. Will that be possible? No lift shift (flat foot shift) dynamically reduces the factory rev limi...

A VersaTuner tune contains only the performance related changes. When you flash a tune, a base tune for your ECU is taken and the performance related changes are applied "on top" of it. This modified base tune is sent to the ECU, replacing the entire tune that was previously there. That's ...

I have a similar experience. I have a 2.0 Skyactiv petrol engine with manual transmission and flashed 93US/98EU pop/crackle tune. I am using 98EU petrol, drove my car for 50km and when I try to get some pop from the exhaust absolutely nothing happens. On the other hand, I think I can notice some di...

There are three possible causes: 1. The ECU may sometimes be stuck in some non-standard mode. Disconnect the battery for 10 minutes to fully reset it and try again. 2. There may be some kind of aftermarket devices connected to the CAN bus of the vehicle, such as gauges, loggers, modules that control...

hi guys, can anyone tell me if it's possible or if you can adapt one of your maps with the lite version? rx8 2003 streetport decat panel filter sl exhaust terminal sohn kit ngk coils The Lite version can only flash official tunes and tunes built by professional tuning partners. Community tunes can ...

Replied via email.

Yes, ND will come next. VersaTuner Lite will be enough to use launch control and no lift shifting.

Do you have an ND or ND2?

I recently purchased Versatuner through Fab9 and flashed my 2013 Mazda Miata NC3. I was contraplating purchasing the upgraded version that would allow me to make changes myself. First I would like to find manual, list of codes, etc that I could read about how to make the changes myself first. I tri...

You are correct, this is an error in our launch control implementation for this car. Please change the rev limiter to 7500 if you wish to retain factory behavior. The error will be corrected in a future update.