i'm not sure where you're getting the max 3.2ms to charge at 9k rpm?? in 1 minute : 60.000ms 60.000ms/9000rpm =6.67ms/rpm Or am i missing something?? Yeah but you're not firing the coil for the entire duration of the compression stroke, are you? Right, so i have 6.67ms total from which i can subtra...

dcox11b wrote: ↑May 9th, 2023, 12:16 pm ....
Hey Walle, would you happen to be able to walk me through or share a bit about your process to get the VE table cleaned up? This would be immensely helpful for my learning.

Cheers

Hello,
yes I would be able to do that. I am "back" was sick and thus inactive.

yes, you can do a lot with it.
Have you purchased the full license ?

you can adjust the common "issues" like temps, rev limits, etc. define less conservative afr targets and improve the VE table by logging under all driving conditions.

you can disable closed loop altogether and than no trims will be built. that wont help with a vacuum leak but that is not often a concern. and a boost leak will only make it richer.. used that when wanted to run 16.5 and leaner AFR for low load (closed loop maxes out at 15.xx, lambda 1.05 )

This is a matter of what the ECU supports, and none of the ECUs used by mazda can do that. Actually very few OEM ECUs on the market support that, or at least dual/multiple tune setups. this is actually not true. but you cant access that protocol with an obd diagnostics tool. every ECU manufacturer ...

bunny hopping / stuttering / jerking in 1st and 2nd on very low load probably in area where Idle ecu logic is taking over.

finally got some time to read in on this.
very interesting aproach.

did you got any problem on low load running and car "jumping" ?

im going to try this together with the Bridgeport and huge exhaust port I'm just finishing thought winter is coming and don't have garage to.....

but why would you mess with torque tables ? imho they are also used when ESC , ESP and TC are engaged. could make for a very unpredictable car.

im looking for someone to help me out with taking the stock fuel map and adding 30% fuel across the board as i don't know how to calculate for that. i suspect im doing something wrong because when i do 0.30 it bottoms out the afr table. just looking for a little more insight. also if someone has a ...

very nice writeup