Search found 1317 matches
- December 21st, 2011, 12:31 pm
- Forum: MAZDASPEED3/Mazda 3 MPS Tuning
- Topic: CL MAF CAL
- Replies: 31
- Views: 49402
Re: CL MAF CAL
No, the car was using the Hypertech tune. Shouldn't the MAF g/s and voltage relationship still apply no matter what the tune was? If it doesn't apply then can you please tell me what's altering it and these should be actual measurements of the amount of air coming into the engine and not something t...
- December 21st, 2011, 11:11 am
- Forum: MAZDASPEED3/Mazda 3 MPS Tuning
- Topic: CL MAF CAL
- Replies: 31
- Views: 49402
Re: CL MAF CAL
I'm not very comfortable to run a high load map with the default MAF CAL at temps around freezing. Since I have a few gigs (literally, 17GB more precisely) of logs captured with my Dashdaq at a very high resolution (over 60 readings per second) in a lot of weather and driving conditions, I was wonde...
- December 20th, 2011, 5:45 pm
- Forum: MAZDASPEED3/Mazda 3 MPS Tuning
- Topic: Map editing
- Replies: 325
- Views: 529111
Re: Map editing
I don't seem to be able to find anything about the wastegate duty cycles, but I'll keep looking.
P.S.: my tactrix is in Koeln/Germany already, so probably I'll get in by the end of the week.
P.S.: my tactrix is in Koeln/Germany already, so probably I'll get in by the end of the week.
- December 20th, 2011, 5:07 pm
- Forum: MAZDASPEED3/Mazda 3 MPS Tuning
- Topic: Map editing
- Replies: 325
- Views: 529111
Re: Map editing
Ok, I've installed the Versatuner. I don't have the tactrix cable yet (I'll get it on Dec 28) so I'm just exploring the maps. Now (obviously) I have a few questions: 1. how to I raise the idle RPM? Under the "Idle" table I have two entries, "Idle RPM 1" and "Idle RPM 2"...
- December 20th, 2011, 10:41 am
- Forum: Announcements
- Topic: Version 1.6.0 released
- Replies: 11
- Views: 34629
Re: Version 1.6.0 released
well, in 6th at 6700rpm you should have about 280Kmph (OBD reported speed which would match the GPS recorded speed you had the 215/45/r18 OEM bridgestones). This should be about 295 - maybe 300 on the speedo
- December 18th, 2011, 7:44 am
- Forum: Mazda 2.3 DISI Turbo
- Topic: Launch Control and No Lift Shift Configuration
- Replies: 2
- Views: 23192
Re: Launch Control and No Lift Shift Configuration
Is it possible (or does it even make sense) to implement LC by controlling the throttle opening rather than cutting the ignition?
- December 17th, 2011, 6:21 pm
- Forum: MAZDASPEED3/Mazda 3 MPS Tuning
- Topic: Map editing
- Replies: 325
- Views: 529111
Re: Map editing
I guess that unless they plug a pressure sensor in your intake manifold they can't really tell how much boost your turbo makes, right? So trust your logs, not theirs, let them tell you only how fast and hard the wheels are spinning the rollers. The K04 reaches full boost on a stock engine/intake/ECU...