Page 2 of 3
VersaTuner for 2016 ND MX 5 Miata Now Available
Posted: April 6th, 2019, 8:30 am
by Franktow
Damn you to HELLLLLLLLLLL. Now I have to go find 8K. Anyone know the odds of pulling off a bank job? I'm more than tempted to sell my MSM, buy the kit and 2 cheap miata's, parts and driver.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: June 13th, 2019, 5:06 am
by SirLevi
This is good news.
Recently purchased VT from Fab9.
Looking forward to Brian's work on my ND Miata.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: June 13th, 2019, 9:33 am
by elektron
I just installed ND VersaTuner sw to my ND 2016 from you (93map). It is awesome
. Did not know that only sw could make so much difference without any other hw modifications. We are in progress of header exchange, in the future, than would like to make dyno run and compare stock map vs. 93map and new map with aftermarket header. I will post it here then. Thank you very, from Slovakia, Europe.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: June 14th, 2019, 3:22 pm
by SirLevi
Posted this Error message when trying to Identify my car using ODBLink SX on my 2018 ND RF Club.
Error: Your ECU is currently running firmware that is not currently supported by this version of Versatuner...ECU Code PSRPEC00xxx...
Looking forward to get this resolved.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: June 19th, 2019, 11:41 am
by SirLevi
The issue has been resolved. Thanks Ignius for the quick turn around.
I would like to collect data using VersaTuner.
What are the parameters I should load for data logging?
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: June 19th, 2019, 7:53 pm
by Ugnius @ VersaTune
Just expand the list of presets at the top of the dashboard screen and load the "General Performance" one.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: June 21st, 2019, 11:12 am
by SirLevi
Got it "General Performance" preset.
Just ordered a right-angle ODBII adapter so I can start collecting logs. OEM connector is over the clutch pedal.
Thanks again Ugnius.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: July 13th, 2019, 4:34 am
by Shadgrind
Do you do a tune for the MX5 ND 181BHP 2.0L?
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: July 16th, 2019, 2:31 am
by Ugnius @ VersaTune
Shadgrind wrote:Do you do a tune for the MX5 ND 181BHP 2.0L?
That ECU is based on an entirely different platform, it uses a different processor, larger memory, different encryption. It will take a significant amount of time and effort to add support for it.
Re: VersaTuner for 2016- (ND) MX-5 Miata Now Available
Posted: July 16th, 2019, 2:47 am
by SirLevi
Thank you for the support Ugnius!
Are there specific procedures in data logging?
Flooring the accelerator pedal on 2nd gear at 2000-4500 RPM...
I am recording KR -4.0 Max on 93 OCT stock tune. Intake temp is 200deg F, oil temp is 180deg F.
Please advice,
Levi