Not hitting load targets

Discussion of tuning specific to MAZDASPEED3/MAZDASPEED Axela/Mazda 3 MPS vehicles

Re: Not hitting load targets

by mituc » September 6th, 2019, 5:27 pm

The MAF cal I've sent him should fix that, among other things. But we will see...
2008 Cosmic Blue Mazda 3MPS
Build engine + WMI + GTX3071, ~476WHP @31-32PSI
2008 Icy Blue Mazda CX7
Stock engine, intake and exhaust (YES!!), GTX2867 gen2 + Autotech HPFP, self-tuned to 320-ish BHP
VersaTuner guru
 
Posts: 847
Joined: December 17th, 2011, 2:47 pm
Location: Iasi/Romania

Re: Not hitting load targets

by Enki » September 6th, 2019, 8:41 pm

The .9v 2.0 g/s thing is a genwon issue and I normally cut the calibration off like that myself. Has there been any discussion of this from anyone on the code side, Mituc? Is it being looked into or are we just SOL?
 
Posts: 35
Joined: December 2nd, 2014, 9:13 pm

Re: Not hitting load targets

by mituc » September 7th, 2019, 10:51 pm

Enki wrote:Has there been any discussion of this from anyone on the code side, Mituc? Is it being looked into or are we just SOL?


I've sent Ugnius a private message pointing to this thread. He seems to have read it. Not sure if he is looking into it, if he's on vacation or has other priorities...
2008 Cosmic Blue Mazda 3MPS
Build engine + WMI + GTX3071, ~476WHP @31-32PSI
2008 Icy Blue Mazda CX7
Stock engine, intake and exhaust (YES!!), GTX2867 gen2 + Autotech HPFP, self-tuned to 320-ish BHP
VersaTuner guru
 
Posts: 847
Joined: December 17th, 2011, 2:47 pm
Location: Iasi/Romania

Re: Not hitting load targets

by Enki » September 13th, 2019, 6:40 pm

:(
 
Posts: 35
Joined: December 2nd, 2014, 9:13 pm

Re: Not hitting load targets

by Dolfius » September 14th, 2019, 4:00 am

@Enki & @JohnnyT are you guys running big turbos or k04s?

What year model is your car @JohnnyT?
 
Posts: 47
Joined: May 31st, 2017, 2:54 am

Re: Not hitting load targets

by JohnnyT » September 15th, 2019, 7:05 am

I'm getting mine figured out. Still working on mafcal but I think it was just me not setting the table correctly. I'll let you know when I get past the mafcal. Mines an 07 speed3 and I'm running a Precision Turbo 5862 journal bearing. Just a little bigger then the ko4 lol.
VersaTuned - 07 Mazdaspeed3 - CPE Stg2 Pistons, Manley HBeams,Kozmic DP, CNT CatBack, PTE 5862 JB Turbo, DTP Fab Dump, CPE PTE Ex Mani, JMF PI IM, CS 3.5Bar, MAC EBCS, HTP 4" Intake, Trubo XS FMIC
 
Posts: 20
Joined: July 6th, 2017, 4:18 pm

Previous

Who is online
Users browsing this forum: No registered users and 4 guests
cron