VersaTune User Forum

I have a 3 port ebcs, according to the install instructions, after installation, the vehicle needs to be tuned for the 3 port ebcs, how do I do this .?

Thanks in advance for any assistance,

Rix

If it's the same as the Grimmspeed, you reduce BCS DC by about 30%.

Just as Steve just stated reduce the BCS table values and start re-tuning from there.
However, you will have to pay more attention to the boost variation because one of the big differences between the EBCS's on the market I think is how they handle boost adjustments (values in the the load correction tables).

If you see load oscillation, lower the bcs dc load correction values.

"by Steve @ VersaTune » August 27th, 2012, 9:54 pm

If it's the same as the Grimmspeed, you reduce BCS DC by about 30%

Is that with all the values in the table ?? including the 100 before 2250 rpm, or only from 2250 to 6500 rpm, and 25% tps to 100% tps

Leave it at 100% below where the turbo spools.