I have installed Versatuner and am currently running the Octane tune. When I tried the OTS tune for the 3” MAF housing it did not run well at all, which I am assuming is because the whole intake pipe is not 3". So the car runs much better on the standard Octane tune.
Was hoping someone could give some advice / insights on the logs I have attached:
- Octane tune - General low speed driving and one 3rd gear pull.
- Octane tune - Re-ran the 3rd gear pull to include Accelerator Position for Virtual Dyno.
- Octane 3 inch / 76mm MAF Housing tune - General low speed driving. Didn’t do the 3rd gear pull as AFRs didn’t look right.
The previous owner was getting 203kW and 430Nm but I’m not sure what boost they were running. I am currently getting 158kW and 340Nm at 17psi but want to make sure the car is running well before chasing power. (In case it matters, I currently have the Versatuner Lite license)