Launch Control - rev limit bounce rate

Discussion of tuning specific to MAZDASPEED6/MAZDASPEED Atenza/Mazda 6 MPS vehicles
Post Reply
Jugmeister
Posts: 6
Joined: August 24th, 2015, 6:04 pm

Launch Control - rev limit bounce rate

Post by Jugmeister »

Added a launch control in with my recent map set at 3300rpm without megaspool. When sitting on the launch control rpm limit the bounce rate seems quite slow to what i was expecting. Is there any way to alter this in the tune to get it to sound like a popcorn limiter?

Thanks.
boloteo
Posts: 36
Joined: November 27th, 2011, 4:33 pm

Re: Launch Control - rev limit bounce rate

Post by boloteo »

no there is no way to increase the bounce rate , but you can enable the megaspool and then the rev limit noise is way better ....It will also raise the boost (that is what is made for )
mituc
VersaTuner guru
Posts: 1329
Joined: December 17th, 2011, 2:47 pm
Location: Iasi/Romania

Re: Launch Control - rev limit bounce rate

Post by mituc »

Enable megaspool, it sounds like a rally car with antilag.
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Jugmeister
Posts: 6
Joined: August 24th, 2015, 6:04 pm

Re: Launch Control - rev limit bounce rate

Post by Jugmeister »

Thanks for replies. Worked a treat.

Now sound and launches like a beast :burnrubber
Post Reply