Sensor Calibration
Posted: September 2nd, 2017, 5:50 am
I am about to install a Bosch 3.5 Map sensor. I understand A: 75, B: 1, OS: -12.5. What I am a little confused about is the settings under Sensor Calibration. Here is my question. Map Scale Additive should be changed to -12.5, Map Scale Base Multiplier should change to 75, and Map scale Second Multiplier should change to 1. I am not 100% sure that I am correct so the rule is to stop and find out. I have changed the dashboard to Bosch 3.5 Bar. Am I correct or off on my thinking?
I also am installing a JBR three port EBCS and read a post from VersaTuner that states to reduce the BCS DC base by 30%, easy to understand and do. Is this still a good starting point for the tune?
Below is what i have done to the car, or am about to do. like the program, just adding this gave the car good pick-up. Not planning on going crazy with it but I do so like the way it will blast through a hole in traffic
2008 Mazda CX-7
ETS inter-cooler, Adjustable BOV, BNR Stage 2 Turbo, JBR 3-Port EBCS, Bosch 3.5 T-MAP, CPE Nviscid Turbo inlet pipe, 3 " Performance Exhaust Manifold, 3" Custom Performance cold air intake
I also am installing a JBR three port EBCS and read a post from VersaTuner that states to reduce the BCS DC base by 30%, easy to understand and do. Is this still a good starting point for the tune?
Below is what i have done to the car, or am about to do. like the program, just adding this gave the car good pick-up. Not planning on going crazy with it but I do so like the way it will blast through a hole in traffic
2008 Mazda CX-7
ETS inter-cooler, Adjustable BOV, BNR Stage 2 Turbo, JBR 3-Port EBCS, Bosch 3.5 T-MAP, CPE Nviscid Turbo inlet pipe, 3 " Performance Exhaust Manifold, 3" Custom Performance cold air intake