VersaTune User Forum

Hi there,

I was helping a mate to install a VersaTuner Base 98EU map in his 3 MPS Gen2 car and I tried to show him how LC works. But it didn't, at all! I remember seen your Max APP thread so, may it be related? In this guy's car maximum value for APP is 69% only. Should I modify LC parameters to get it working?

Cheers.

When using launch control make sure you press the acceleration pedal to the floor instantly, while the RPM is still low. If the RPM builds up and the APP os not above the desired value (usually no matter what you set in the versatuner software it is still 98 or 96%) then the RPM will go above the LC setting. So pres the clutch pedal, and floor the acceleration pedal as fast as you can.

I have the launch control RPM set to 2600rpm and I have to be VERY quick. so I know

Nothing, I tried a thounsand times! Flat Foot Shifting doesn't work too! Has anybody similar problems?

Nobody?

I guess at this point you should contact Steve/Ugnius directly to determine what the problem is...

Did you get this resolved?

Nope, I didn't, I tried contacting Ugnius by mail with no luck until now. Right now my friend is pissed off and decided not to use VT for now until LC issue gets resolved. Any ideas Steve?

Sent from my HTC One using Tapatalk

When you flash a tune, there is a series of screens that you click Next on to continue. Does the Tune Customizer screen show that LC is enabled?

What version of VersaTuner is installed?

Steve @ VersaTune wrote:When you flash a tune, there is a series of screens that you click Next on to continue. Does the Tune Customizer screen show that LC is enabled?

What version of VersaTuner is installed?

Yeah, of course, I always checked it because first time I though it was my fault. Version is 1.8.10

Sent from my HTC One using Tapatalk

LC/NLS is working fine on my 2011 MS3. What are your threshold settings? LC km/h, LC rpm, NLS rpm, app?