Throttle respond

Tuning discussion for all second generation Mazda 2.3 MZR DISI Turbo powered vehicles
Post Reply
r-jscheib
Posts: 15
Joined: March 1st, 2022, 1:59 pm

Throttle respond

Post by r-jscheib »

Hello.
Is there any way to adjust the throttle respond.
Trying to eliminate a bit of legging.

Cutless high flow DP, HPFP, BOV, SHOR RAM INTAKE.

CHEERS.
2013 MS3 , MODS; CS HPFP INTERNAL; CS SRI; CATLESS DP; RACE PIPE; BOV :drive
mituc
VersaTuner guru
Posts: 1324
Joined: December 17th, 2011, 2:47 pm
Location: Iasi/Romania

Re: Throttle respond

Post by mituc »

There are several ways to eliminate throttle response depending on what is causing most of it.
In your case considering the mods you have the throttle response should actually be close to out of control anywhere from 2200-2500rpm up. So post a log using this logging preset: https://www.dropbox.com/s/rznsz9p17ma4i ... vtpre?dl=0 Please capture the moment when you press the acceleration and you wish you had more pedal, so a few seconds per log. Take 3-4 logs. Also take two logs two minutes log each with the car idling and driving normally through traffic. Post the .zip archive here and let's start from there.
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
r-jscheib
Posts: 15
Joined: March 1st, 2022, 1:59 pm

Re: Throttle respond

Post by r-jscheib »

Alrigh. i do some logs and lets go from there.
thanks mituc
2013 MS3 , MODS; CS HPFP INTERNAL; CS SRI; CATLESS DP; RACE PIPE; BOV :drive
Post Reply