Page 1 of 1
Help with Tune Editor and MAFcal
Posted: October 1st, 2020, 5:11 pm
by DarthTater92
So I'm pretty much needing some help with the how to as far as editing MAF values after running 40+ miles. I'm running a bit lean
Re: Help with Tune Editor and MAFcal
Posted: October 2nd, 2020, 3:39 pm
by mituc
Post a log and your current tune..
You should start by adding half of the fuel trims values as percent to your MAF values.
Re: Help with Tune Editor and MAFcal
Posted: October 3rd, 2020, 1:39 am
by DarthTater92
Ok so if my lyft is 20%, go to sensor calibration/Maf sensor then highlight all values, multiply by 1.2?
Re: Help with Tune Editor and MAFcal
Posted: October 3rd, 2020, 1:39 am
by DarthTater92
I'll post a log, just away from my computer right now