New v1.08 tunes published in the database

[Steve @ VersaTune]

I just published the v1.08 tunes. 1.08 has a lot of road testing time on it. 1.10 will be published as soon as I clean up the high rpm oscillation.

[Elyssa]

Very NICE
What is the difference between 1.08 and 1.06?

Thank you

[Steve @ VersaTune]

1.08 has Higher torque targets.

[Steve @ VersaTune]

It's easy to compare them. In Tune Editor, open 1.08 and set 1.06 as the comparison tune. All of the changes will be in bold.

[bamse1]

Hello guys and congratulations for 1.08, I felt a pretty big difference comparing to previous 1.06.
Since I'm not very good with reading dyno sheets, please tell me what is the difference in torque and horse power between the 2 versions (1.06 and 1.08), I've looked over the 2 versions in Tune Editor but I'm not sure I know how to read those multiple values, so I'm asking you guys to give me a simple answer regarding the power / torque gain in 1.08 (also, please specify if the numbers mentioned by you are in terms of wheel power or theoretical power).
Thanks again!

[Steve @ VersaTune]

We did not test 1.06 on the dyno, so we don't have any direct comparison between them.

[asphyx82]

Hi Steve ! , do you think to release future update for V1.08 and/or new tune?

[Steve @ VersaTune]

There will be additional tunes. We are still working on ways to lower EGT and smooth power delivery.

[bamse1]

Hello Steve, any news regarding the 1.08 update that you've been working on?

[Elyssa]

Hi Steve,

Any news regarding 1.08 update? I still have my issues with dropping power at high rpm. Now that's hotter in my region and the power limitations are very frequent. I have around 3 - 4 power limitation zone's after 3200 rpm, each time the engine is in full throttle (everything above 80%). Can this lead to mechanical failures? Is 1.08 safe for use? Should I revert back to the factory map? There are some mechanical upgrades needed?

What are your recommendations?
Thank you