VersaTune User Forum

I just published the v1.08 tunes. 1.08 has a lot of road testing time on it. 1.10 will be published as soon as I clean up the high rpm oscillation.

Very NICE
What is the difference between 1.08 and 1.06?

Thank you

1.08 has Higher torque targets.

It's easy to compare them. In Tune Editor, open 1.08 and set 1.06 as the comparison tune. All of the changes will be in bold.

Hello guys and congratulations for 1.08, I felt a pretty big difference comparing to previous 1.06.
Since I'm not very good with reading dyno sheets, please tell me what is the difference in torque and horse power between the 2 versions (1.06 and 1.08), I've looked over the 2 versions in Tune Editor but I'm not sure I know how to read those multiple values, so I'm asking you guys to give me a simple answer regarding the power / torque gain in 1.08 (also, please specify if the numbers mentioned by you are in terms of wheel power or theoretical power).
Thanks again!

We did not test 1.06 on the dyno, so we don't have any direct comparison between them.

Hi Steve ! , do you think to release future update for V1.08 and/or new tune?

There will be additional tunes. We are still working on ways to lower EGT and smooth power delivery.

Hello Steve, any news regarding the 1.08 update that you've been working on?

Hi Steve,

Any news regarding 1.08 update? I still have my issues with dropping power at high rpm. Now that's hotter in my region and the power limitations are very frequent. I have around 3 - 4 power limitation zone's after 3200 rpm, each time the engine is in full throttle (everything above 80%). Can this lead to mechanical failures? Is 1.08 safe for use? Should I revert back to the factory map? There are some mechanical upgrades needed?

What are your recommendations?
Thank you