Page 1 of 2

Tune Sharing

Posted: June 7th, 2018, 5:50 am
by TZangara
Different modifications may need additional changes to maps. I will start off with a dwell map change, D585 Coils.

Re: Tune Sharing

Posted: June 9th, 2018, 7:49 pm
by gearsoft
TZangara,

I downloaded your tune yesterday and see that you added the same map I have for the d585 coils. Its been working great for me and my coils have been lasting a while since I added this map. I've also been running a modified oil map, some cooler fan settings, rev limit changes and other mods very successfully for over 6 months now and decided to merge the new VersaTuner tune with my tune. The result is very promising and it does fell like the top end has more pull to redline and rev limit. I've included this tune and I pasted the description below that has the basic mods in this tune. If you decide to flash it make sure it merges with your original maps fine before you flash it. VersaTuner does a good job of warning you about this too...

Original tune downloaded from Versatuner's "Available Tunes":
Catback exhaust, High Flow Catted mid-pipe, and KN panel filter
AFR changes
VDI opening moved to 7700
APV opening moved to 6400
raised load limits
+1.5* timing at high load/rpm
---
My tune additions:
9700 RPM rev limiter
177 MPH speed limiter
-10 deg fan temps
15% oil increase under 4500. Nothing over 60
20% oil increase over 4500. Nothing over 60
d585 coil dwell
---
Added in the "Tune Customizer" settings while flashing:
P0139, P0420 defeat
Launch 7250
No lift 8750
---

Mods to my 04 rx8-->
Rebuild w/mild streetport
Midpipe
BHR ignition W/10mm wires
VersaTune ECU programming:
Lightweight flywheel
Tein coilovers
SOHN adapter (2 stroke oil)
Oil pressure increase
Catch can (removed and added ventilation kit)
Ventilation kit N3Y1-13-S80A and new vacuum line diagram (service bulletin 01-050/06)
Bluetooth to factory stereo and OBDII
More...
<--

Fun times!

Re: Tune Sharing

Posted: March 10th, 2019, 11:58 am
by Bob_chala
Your AFR are richer than stock !! :shock: Why ?

Re: Tune Sharing

Posted: November 15th, 2020, 3:19 am
by Clem008
Hello .
Is your melody for a 2007 rx8 with stainless steel catback decatalyst, pipercross air filter and D585?
I see that there are all the improvements in mop (huile)level and radiator temperature.
Thank you

Tune Sharing

Posted: October 2nd, 2021, 5:39 pm
by Toxic_RX8_
This is what I'm running :burnrubber

Re: Tune Sharing

Posted: October 4th, 2021, 9:10 pm
by Walle
Toxic_RX8_ wrote: October 2nd, 2021, 5:39 pm This is what I'm running :burnrubber
would be nice to have your engine mods listed as well here before downloaded. also a short list of ecu map mods

Re: Tune Sharing

Posted: November 27th, 2021, 3:31 am
by Toxic_RX8_
Fresh streetport with 2mm goopy apex seals
D585 coils
AEM Intake
Elite Headers
Agency downpipe
Agency catback

Re: Tune Sharing

Posted: April 12th, 2022, 7:08 pm
by Komic
Can these be modified?

Re: Tune Sharing

Posted: September 1st, 2022, 1:21 pm
by pfknrx8
I have a 2004 Any suggestion what tune to download with the following mods , I haven’t flashed anything since I’m purchasing the Elite version and will be doing this weekend

Turbo XS exhaust
BHR midpipe
BHR coils
S2 tranny w/ S1 diff
Exedy HD clutch plate ( 6 puck ) disc
High Output Alternator 200 using 4awg wire
AEM Intake
Ryan Rotary Sohn adapter
Hot Inazma Ground Kit using 8awg wire
Óptima Red Top Battery
Koyo radiator with coolant adapter sensor
HKS suspensión Coilovers
( stock wheels ) 235/40/18 Cooper Tires
All valve solenoid replaced
All 4 plugs replaced
Fresh Idemitsu oil change
Crankshaft sensor also replaced
New Throttle installed

Re: Tune Sharing

Posted: September 18th, 2022, 1:19 am
by Walle
this one "6-port_ 91US_95EU Octane Stage 1 RX-8 with REVi Intake and TurboXS catless exhaust v1.05.vtune" and than changih some values as defined here:
viewtopic.php?f=19&t=4195