Page 1 of 1

Ported RX8

Posted: July 2nd, 2019, 9:32 pm
by Statesy
Hi I am after advice, I’m new to tuning with software I’ve been away from the scene a long time with the last tuning in a turbo RX7 and Microtech hand held ecu. My question relates to which tables should I adjust for idle mixture? The engine is ported using the racing beat templates on all ports including exhaust and would like to get the idle a little lumpy. Also any advice on which parameters to log while progressively adjusting the tune? I’ve got RPM, commanded AFR, actual AFR, knock. Will the ports make it run lean in the upper rpm range? Thanks

Re: Ported RX8

Posted: February 24th, 2020, 12:19 am
by LedFlava
Hi Statesy. How did you get on with your tune? I'm starting down the same path and keen to learn from others, where they went with the tune, and what they've tried.

Re: Ported RX8

Posted: February 24th, 2021, 3:51 am
by malijames12
LedFlava wrote: February 24th, 2020, 12:19 am Hi Statesy. How did you get on with your tune? I'm starting down the same path and keen to learn from others, where they went with the tune, and what they've tried.
Hey, I'm in the same boat as you!

How are you getting along with your tune? I'm trying to figure out what to do for my streetported engine that's currently being assembled.