NC1 Disable Immobilizer issues

Tuning discussion specific to 2006-2008 NC1 Miata MX-5 vehicles
Post Reply
Posts: 2
Joined: December 1st, 2019, 4:18 pm

NC1 Disable Immobilizer issues

Post by abitor123 »

I deactivated my imobolizer but it still active. Is there an extra step to disable it?

Posts: 1
Joined: July 19th, 2019, 2:52 am

Re: NC1 Disable Immobilizer issues

Post by wooglins »

I am curious about this as well. It is an important option that I need to activate on my 2006 NC1. Watching.

VersaTuner guru
Posts: 972
Joined: December 17th, 2011, 2:47 pm
Location: Iasi/Romania

Re: NC1 Disable Immobilizer issues

Post by mituc »

The immobilizer is a different system. It will decide if it will power the ECU or not. Versatuner can only change the actual ECU calibration, not other subsystems.
However, what you guys want can be done with the Mazda shop tools, IDS or however is called. Forscan may be helpful as well.
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071, ~476WHP @31-32PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 320-ish BHP

Post Reply