VersaTune User Forum

Hi, my Mazdaspeed 3 (2007) throws after the last Update P610 and U2064 error Code after i reflesh my ecu. I tryed to reflash the ECU again after that but the Errorcodes are comming back after 2 Starts of the Car can you help me out with it?

btw is it possible to "livelog" the car with connecting the Tables to the Logging while driving? On another Tuning software i used this was possible and a very helpful future...

Do you have any weird lighting in your car? ...LEDs, additional light bulbs added?
How is your battery?

I dont have additional lights or special electronics on my car, my battery is almost new so its not a electronic issue... i have this error code after flashing my car...

You are saying it started happening after the last update - do you remember what version of VersaTuner you had previously?
If you clear the codes in the "DTCs" tab of VersaTuner, do they come back?
Could you please email the files named [yourvin].bck and UserSettings.xml from the VersaTuner data folder to [email protected]? You can open the data folder by going to Settings on the home screen and clicking "Open VersaTuner Data Folder..." at the bottom.

Live tuning is not available at the moment, but it is on our wishlist of features.

I experienced this as well on a friend's car. So this is the context:
- his version1 Versalink cable failed while flashing a new tune, right after the "deleting previous tune" message;
- as a result, his car remained where it was because the engine could nto start;
- because I did not know the reason why his cable failed I preferred to use my cable and my tabled to fix his car;
- when I attempted to flash his last tune the versatuner wanted to flash a recovery tune first;
- after the recovery tune it wanted to go through the 25 minutes process of installing VT on the ECU and backing up everything;
- because my tablet did not have his OEM firmware backup file (was on his laptop) I reckon that whatever was on the car (installed versatune + recovery map) was taken as factory. I'm not sure of the impact of installing VT over this existing installation, normally it should be no impact but I don't know;
- after finally flashing his last tune the check engine light came on after the 2nr or 3rd start later that day.
For now I just cleared the error (his cable is not fixed, probably he will end up buying a new obdlink mx) but if this will not get better I will just get the .bck file from his laptop, overwrite whatever is on my tabled, try a factory restore and a reinstall.
I'll keep you posted.

Ok, the error came back.
Previous owner doesn't have the original firmware file VIN.bck any more.
Not sure how to go about this one. Since the check engine comes back only after the car is started cold after sitting a while and not during driving it I'm kind of tempted to suppress this PID from versa, but because it's triggered means that something is not quite right.