I'm attaching the 3rd gear pull of my last tune. I've almost nailed the BCS (matches load to 1/100th of targeted most of the range), however I noticed strange thing. My DBW tables are adjusted, smoothed, but still target 80 from 1.8 onwards since 3k rpm, and even earlier on higher rpm. However, as seen on the log, Throttle opens only to 74 even 4k+ RPM.
Why does it do that? I'm targeting 80 there.
p.s. I can't upload attachements to the forum.
https://skydrive.live.com/redir.aspx?ci ... csGNC0qZKI
https://skydrive.live.com/redir.aspx?ci ... XquOChHZtk
Throttle does not open fully
Re: Throttle does not open fully
I guess 76-77% is all you can get. And 74% looks pretty close. As long as you hit your per gear load limits you're fine.
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Throttle does not open fully
76% rts is 100%. It wont go over that. 80% is just to make sure that u open the throttle all the way
-
- Posts: 383
- Joined: August 3rd, 2011, 11:29 am
Re: Throttle does not open fully
As long as you're hitting load targets don't worry about the throttle position, the ecu uses throttle closing to control load
- Steve @ VersaTune
- Lead tuner
- Posts: 1157
- Joined: March 29th, 2010, 12:58 pm
Re: Throttle does not open fully
The ECU averages in the previous several cycles of throttle position to smooth the throttle opening. As a result, it takes a little while to get the throttle to open that last few percent.
Re: Throttle does not open fully
got it! that one is accounted for