Hi, I'm trying to determined which is the best launch control config. but to start with, we need to share
Right now i'm running Default, because I just got my versatune installed on the car running High load map with high Downpipe
What is your config?
Cheers
What is YOUR Lanuch control config?
Re: What is YOUR Lanuch control config?
Default.
Mazda 6 MPS, BPV GFB, RX-8 wheels, B8 + Eibach Pro-Kit, CS 3" SRI, GS EBCS (interrupt), CS 3" TMIC, EGR off, HPFP internals, CS catted downpipe, 3 bar MAP, BNRS3, forged engine and stuff
Re: What is YOUR Lanuch control config?
3500rpm for launch control, 4800rpm for no lift shift. However, after I went big turbo I never used any of them as I'm too scared yet (peak power around the rev limit).
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Re: What is YOUR Lanuch control config?
6000 RPM
400+ Mazda6 MPS
ATP GTX3071, AEM SRI, CPe TIP, Treadstone TR11 FMIC, 3" Rud Exhaust, KMD HPFP, Methanol Injection Kit, CP Forged Pistons, K1 Forged Rods
Tuned with
ATP GTX3071, AEM SRI, CPe TIP, Treadstone TR11 FMIC, 3" Rud Exhaust, KMD HPFP, Methanol Injection Kit, CP Forged Pistons, K1 Forged Rods
Tuned with
Re: What is YOUR Lanuch control config?
Big diffidence between 3500 and 4000 as original? and also 6000?