MAF CAL creating high load values
Posted: August 1st, 2021, 6:28 pm
Hey everyone, hoping to have some light shed on my situation:
Trying to get the MAF CAL right on a 3.5 inch housing is creating an issue,
To get the STFT and LTFT values to be close to 0, the g/s and load values are going out the door (over 2.6 load, and over 350g/s at 16psi)
This is a stock KO4, downpipe, 3.5 inch intake and a fmic.
When the load values are more realistic (2.2, 280g/s @18psi) the STFT is around 25-30%
Ive done a boost leak test and all is ok.
Can anyone shed any light on what might be the issue here?
Trying to get the MAF CAL right on a 3.5 inch housing is creating an issue,
To get the STFT and LTFT values to be close to 0, the g/s and load values are going out the door (over 2.6 load, and over 350g/s at 16psi)
This is a stock KO4, downpipe, 3.5 inch intake and a fmic.
When the load values are more realistic (2.2, 280g/s @18psi) the STFT is around 25-30%
Ive done a boost leak test and all is ok.
Can anyone shed any light on what might be the issue here?