Page 1 of 1
Shutter valve removal
Posted: November 27th, 2024, 1:36 pm
by Edain
Hello teams,
I hace a questión, I want to know what I need to remove the Shutter valve, I have no fault or codes, but I have investigated and it restricts the air flow. Do I need any reprogramming or just remove the DTC?
Thanks for your help...
Re: Shutter valve removal
Posted: November 27th, 2024, 4:17 pm
by mituc
You will have to take the intake manifold off, remove the flaps, the cut the shaft and only leave a small portion of it enough to cover the hole in the intake manifold, and then everything else on top of the intake manifold: shutter valve, actuator, position sensor, and so on.
Of course you will get some codes which you can remove later.
Re: Shutter valve removal
Posted: November 27th, 2024, 7:59 pm
by Edain
I appreciate your help mituc,
So, I don't need to reprogram or add extra value to the ECU, just eliminate the p2006 code?
Re: Shutter valve removal
Posted: November 27th, 2024, 10:31 pm
by mituc
Yes, just eliminate the codes that come up after that, 2006, 2009, whatever you may get from the same interval.