Does not show big load

[YuraL]

Why does not show the load more than 2.3-2.35 in Versatuner logs?

[Ugnius @ VersaTune]

Could you clarify the problem? Is it only doing that in the log viewer? Does it show more than 2.35 on the dashboard when driving the car around? If I recall correctly, Steve was logging up to 3.0 load successfully.

[YuraL]

It's doing on the dashboard too. Real load is around 2.5.
As I know, there is no problem with this in the 3MPS.

[mituc]

I can confirm there's no problem with this with the 3MPS, I've seen load values of 2.38 myself (once when boost spiking last winter) and of 2.8-2.9 in some logs of a guy from Germany running a gtx3076 on pump gas.
And if my estimations are correct 265g/s at 4000rpm is indeed load 2.55-2.57 on this engine assuming that you did not touch the volumetric efficiency table.

[DJJUT]

I have been seeing this same issue too..... any more information on this?

[Ugnius @ VersaTune]

Did this behavior only appear in the latest version?
Were you able to log large loads with older versions?

[YuraL]

I have never seen a load greater than 2.3-2.35, with all versions.

[Ugnius @ VersaTune]

I have never seen a load greater than 2.3-2.35, with all versions.

Could you please record a log with high load (presumably over 2.35) and these parameters:
Absolute load
Engine RPM
Accelerator pedal position
Relative throttle position
Manifold absolute pressure - Bosch 3 BAR
Mass airflow
Knock retard
Ignition timing advance
Wastegate control solenoid DC
Actual equivalence ration (lambda)
MAP sensor voltage
Fuel injection pulse width

You can post it here or email it to us.
Thanks!

[YuraL]

In the attachment to this post

[YuraL]

And from another car