Hey guys, I'm able to cause the application to throw an exception (index out of range) by doing the following:
1. Open a table
2. Click a cell somewhere in the middle
3. Click Ctrl + A to highlight all cells
4. Now reset the selected values to the tune in comparison (this is when the exception happens)
One thing I also noticed is that it resets some columns when this happens, but not others.
Exception thrown
Re: Exception thrown
This is happening for some time now... after you work on a few tables with either complete selection or partial selection of a high number of tables.
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Re: Exception thrown
I reported this error a while ago, didn't get fixed so I learned to go around it. I'm saving the tune more often, and when the exception occurs I right click the window in the task tab, chose to close it, Versatuner will tell me if I want to save the tune which I do, and then start from where I left.
It does that only when big tables are involved and when you copy/paste big table chunks several times.
It does that only when big tables are involved and when you copy/paste big table chunks several times.
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP
Built engine + WMI + GTX3071 gen2, ~509BHP @34PSI
2008 Icy Blue Mazda CX7
Stock engine and exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 330-ish BHP