Completely stock 2023 ND2 MX-5
No CAN gadgets, bone stock,
Error occurred after “backing up stock tune” phase ram for about 25 minutes.
Error was “Could not get the number of available bytes (Error code: FT_IO_ERROR)
I have installed all drivers from the versatune website.
This is a windows 10 laptop with basically nothing on it.
OBD connection was secure.
Anyone have recommendations? I haven’t seen this error anywhere when searching online.
Installation Error
Installation and Usage Support
Jump to
- General
- ↳ Announcements
- VersaTuner
- ↳ Software Support
- ↳ Feature Requests
- ↳ Hardware Support
- ↳ Professional Tuners
- ↳ Mazda 2.3 DISI Turbo
- ↳ Gen 1 Tuning
- ↳ MAZDASPEED3/Mazda 3 MPS Tuning
- ↳ MAZDASPEED6/Mazda 6 MPS Tuning
- ↳ CX-7 Tuning
- ↳ Gen 2 Tuning
- ↳ MAZDASPEED3/Mazda 3 MPS Tuning
- ↳ Mazda RX-8
- ↳ Series II Tuning
- ↳ Series I Tuning
- ↳ Mazda SkyActiv Diesel
- ↳ CX-5 Tuning
- ↳ Mazda3 Tuning
- ↳ Mazda6 Tuning
- ↳ Mazda MX-5 Miata
- ↳ ND
- ↳ Mazda LF Engine
- ↳ NC Miata MX-5
- ↳ NC1
- ↳ NC2/3
- ↳ BK Mazda3
- ↳ Mazda L3 Engine
- ↳ BK Mazda3
- ↳ GG Mazda6
- Tuning Community
- ↳ Discussion in Russian Language / Дискуссия на русском языке