Maybe this is a bit too early, but I had sent an electronic mail to the support team and had yet to receive a response. Since my purchase, I have been experimenting different tables to see which one takes into effect. While some tables do go into effect, many others are not budged, and there are unfound tables?
I am trying to properly tune for E20 fuel but find it troubling for it cruise at Lambda 1 (14.7:1) in low to moderate load despite adjustment in the software.
Maybe I am doing something wrong? Could it be because I am using a non-J2534 wire to flash? Or the discovered tables were specifically from the manual transmission ECU (different ROM and configuration; assumption due to the gear ratio default input values)? I like to get this resolved in hope that we can further polish the software for our platform and find more potential!
Non-Working Tables from Personal Vehicle Testing:
- Closed Loop Low Load AFR Target 1
- Closed Loop Low Load AFR Target 2
- Closed Loop Low Load AFR Target 3
- Fuel Enrichment Unk1
- Fuel Enrichment Unk 2
- Volumetric Efficiency 1
- Volumetric Efficiency 2
- Volumetric Efficiency 3
- Volumetric Efficiency 4
Anyone having similar experience?