Page 1 of 1

OBDLink SX is now supported!

Posted: April 5th, 2019, 6:05 am
by Steve @ VersaTune
We are excited to announce that OBDLink SX cables are now supported by all versions of VersaTuner.
Logging and flashing are somewhat slower than VersaLink, but the price point of the OBDLink SX is quite attractive.

OBDLink cables can be purchased at scantool.net

:beertoast

Re: OBDLink SX is now supported!

Posted: July 25th, 2019, 6:05 am
by SpdFrK_528
Versatune does not recognize/see my OBDLink SX, like its not plugged at all but it is.

- Firmware updated
- Drivers OK (Windows says so...)
- Windows 7 32 bit.

Re: OBDLink SX is now supported!

Posted: July 26th, 2019, 4:07 am
by Ugnius @ VersaTune
Please open VersaTuner settings (click the gear in the top right corner) and make sure that OBDLink SX is selected as the vehicle interface as shown here:
OBDLink SX.png
OBDLink SX.png (33.69 KiB) Viewed 8872 times
Then when you try to identify your car, make sure that ignition is turned on.

Re: OBDLink SX is now supported!

Posted: April 5th, 2021, 12:50 pm
by Boomdoggy18
How do you change to a USB cord? My only choices shown are Bluetooth options

Re: OBDLink SX is now supported!

Posted: April 5th, 2021, 1:25 pm
by Boomdoggy18
Now I'm receiving this error code The calling thread must be STA because many UI components require this