Bosch 4BAR MAP sensor 0281006102

[mituc]

For those who self-tune and you have this sensor, this is the calibration you need to use:
Multiplier: 90
Offset: -5

So in Versatuner you can set the Base Multiplier to 90, Second Multiplier to 1 and Offset to -5.

I've seen a lot of calibrations flying around from various tuners (which I'd expect to know better, but for some reason they do not care) and they were all wrong by a lot (based on min/max MAP values assuming they were always at 0.5 and 4.5V, which is not always the case).