Load targets

VersaTuner for Mazdaspeed6, Mazda 6 MPS, Mazdaspeed3, Mazda 3 MPS, CX7
Post Reply
mituc
VersaTuner guru
Posts: 1426
Joined: December 17th, 2011, 2:47 pm
Location: Iasi/Romania

Re: Load targets

Post by mituc »

Even if you're on the stock K04 there is no reason why you should not command 100% WGDC at least up until 1.5k rpm. Not even the K04 can't boost too much there (not even at 2k but it can start boosting a bit there if you open up the exhaust).
2008 Cosmic Blue Mazda 3MPS
Built engine + WMI + GTX3071 gen2, ~550BHP @35PSI
2008 Icy Blue Mazda CX7
Built engine and stock exhaust (YES!!), JBR3" + GTX2867 gen2 + Autotech HPFP, self-tuned to 360-ish BHP
Top
User avatar
joey
Posts: 51
Joined: November 2nd, 2011, 8:12 am
Location: South Afirca

Re: Load targets

Post by joey »

mituc wrote:Even if you're on the stock K04 there is no reason why you should not command 100% WGDC at least up until 1.5k rpm. Not even the K04 can't boost too much there (not even at 2k but it can start boosting a bit there if you open up the exhaust).
Looks like I will have to take the car to Mazda... I can't fix this bcs wiring.. Now they are going to bleed me dry. Cars are so expensive here in SA :cry:
Versatune,FMIC,3"SRI,3"TIP,HKSSSQv4,3"Turboback,Devil'sOwnWMIStg2kit,AutotechHPFP,JBREGRdelete,JBRBSD&Baffleplate,RacingLogiccoilovers,TRZTMM,AWRPMM,SURERMM,SUREShortcut&Counterweight,SUREg/knob,ApexiTT,HDIStg2Evoboostcontroller
Top
Post Reply

Return to “Mazda 2.3 DISI Turbo”